EVSE Interface J1772
The EVSE Interface allows you to charge your EV from standard AC (L1 and L2) charging stations using the SAE J1772 standard. It works with both Type 1 connectors (USA, Japan, etc) and Type 2 (Europe, Australia, etc).
EVSE Interface J1772
It can be used in any application where its Charge Enable output is set up to turn on the vehicle’s onboard charger, normally via a BMS to handle over-voltage protection.
A maximum charger power of 13.3kW per phase is supported, but a recommended charger is the 6.6kW TC HK series, or other brands using TC’s CAN protocol (Elcon, Ovartech, Greatway). Type 2 connectors support three phase charging which allows you to use 3x 6.6kW chargers for a 20kW charge rate, but note that 3-phase charging is not supported by all charging stations.
Installation is quite simple, with just two wires from the charging connector to the EVSE Interface (Pilot and Prox), a Charge Sense wire from the EVSE Interface to the EVMS, and optionally two wires for CAN bus between the EVSE Interface and EVMS. There is also an LED output which can be used to wire a remote LED in the charge door, which will flash while charging, or stay on once charging is complete (if EVMS CAN bus integration is set up).
J1772
4 Items
Question & Answer:
Q :
I have a technical question about this product. Is their an output signal through CAN or analog, which indicates that there is a charge plug connected to the vehicle. I've seen the Chg output, but I'm not sure if this is also active when the vehicle is not charging (because it is fully charged).
I want to make sure that the vehicle can not drive when a charge cable is connected to the vehicle.
Could you please also provide me with a DBC file for can bus communication with a BMS system?
The EVSE Interface allows you to charge your EV from standard AC (L1 and L2) charging stations using the SAE J1772 standard. It works with both Type 1 connectors (USA, Japan, etc) and Type 2 (Europe, Australia, etc).