

No supplier
Reference: Gigavac P115 Mini-Tactor
Brand: GIGAVAC
Gigavac P115 Mini-Tactor Contactor P115xDA series relay has a small, lightweight, and cost effective patented design.
Banner
Prius II Throttle Accelerator Pedal
Made of high quality materials which prove to be very reliable.
Made of high quality materials which prove to be very reliable. This pedal is easy to use and can give even the oldest of vehicles a new car feel with this drive-by-wire assembly.
These Standard OE Motor accelerator pedal sensors indicate the position by converting pedal movement and position into an electrical 0-5V signal.
Pin 6 - Wiper 1
Pin 5 - Ground
Pin 4 - 5v +
Pin 3 - Wiper 2
Pin 2 - Ground
Pin 1 - 5v +
Reference: TBMSREPPCB-V1
Tesla BMS replacement board Rev1 This is not a BMS board.
Reference: LDUAlCasing
This solution is made for all Tesla Large drive unit split setup
Reference: 776164-1
35 pin Molex for SME and Curtis controllerSold with 35 pin
Reference: TESfp3
Brand: TE CONNECTIVITY
Superseal connector female 1 to 5 pin TE connectivity superseal connector wire to wire
Reference: TslExchangerRep
Aluminum plate for motor oil direct colling. This device allows you to cool directly the oil from the motor and reductor into the oil radioter directly. This device replaces the water oil heat exchanger
Reference: KNOB-DNR
ELECTRONIC SHIFT KNOB G-N-D FOR ELECTRIC VEHICLE CONVERSION
Reference: 770680-1
23 pin Molex for Tesla Large Drive UnitSold with 23 pin
Reference: MH-1170S-150DZ01
PTC Heater 144V / 1700W PTC Heater 144V / 1700W @ 6.4m/s
Reference: CD5-F
CD-5F (Flat Panel) Carbon Digital Dash Displays feature a full-color, daylight readable screen surrounded by a tough, lightweight flow-molded carbon fiber composite housing. Seven ultra-bright LEDs span the top of the display housing for RPM and shift light indication. Users can program them to ascend in specific increments based on RPM range and flash...
Reference: TS2LDV
Tesla Large Drive Unit 4 Pin Encoder Connector Model S & X This 4 pin plug fits the Tesla large drive unit encoder outlet on the base and performance drive units. This is a complete kit including pins to crimp on your cur cables to allow you to build a professional loom.
Reference: 3Dphaseprotection
Hyper9 Phase 3D printed inverter protection Perfect to avoid any contact with the high voltage connection.
Reference: TESfp3m1
Brand: TE CONNECTIVITY
Superseal connector male 1 to 5 pin TE connectivity superseal connector wire to wire
Reference: PF01A15x-30x
Semiconductor Fuse holder 1000a - PF01A15x-30x
Prius II Throttle Accelerator Pedal
Made of high quality materials which prove to be very reliable.
Chat with us on WhatsApp